Midland G9 Plus - Automatic Out-Of-Range; Display Illumination; Power Save; Battery Recharge

Midland G9/G9E Plus instruction guide | 21
Automatic Out-of-Range
By setting this mode a pair of G9 Plus is transmitting every 30 seconds a data
control code. As soon as the contact between both units is getting lost and one
radio doesn’t receive this data control code twice consecutively, the icon OUT
starts flashing in the display and you will hear a beep tone.
This function can be activated only if the “Emergency” feature is disabled.
Activating – Deactivating
1. Press MENU till the display shows “OUT” and “Or of”, select “Or on”
(activated) with the ▲▼ buttons.
2. Switch o both radios.
3. Turn them on at the same time.
To disable this function:
1. Push MENU till “OUT” and “Or on” are displayed;
2. Select “Or of” (disabled) with the ▲▼ buttons.
3. Confirm your selection by pushing PTT or wait for 5 seconds.
Display illumination
If there is insucient light to read the display, press briefly EMG and the di-
splay illumination will activate for about 5 seconds. Every time the MENU is
pressed, the display will automatically light up.
Power save
The battery power saving feature enables a reduction in the consumption of up
to 50%; power saving comes on automatically when the transceiver does not
receive any signal for more than 7 seconds. When the batteries are dischar-
ged, the icon
CALL
MENU
EMG
15
24
23
22
21
20
19
18
17
16
3
2
1
14
13
12
10
9
11
8
7
6
5
4
appears on the display: replace the batteries or recharge the
battery pack.
The power save is active only if the Emergency function is disabled.
Battery recharge
Connect the socket of the wall adaptor to a mains power socket and insert the
jack of the wall adaptor into the desktop charger plug. It takes 12/14 hours to
fully recharge.