ROGER BEEP (end of transmission) TONE
When the PTT button is released, the radio will beep to confirm to
other users that your transmission has finished.
To turn the ROGER BEEP tone on, press the MENU button until the
display shows an “rb” icon while on the right of the “rb” display, an
“oF” icon appears. Select “on” by pressing the buttons and push
the PTT key, or press MENU button to move to the next feature
setting.
To turn the ROGER BEEP tone off, press the MENU button until the
display shows an “rb” icon while on the right of the “rb” display, an
“on” icon appears. Select “oF” by pressing the buttons and push
the PTT key, or press MENU button to move to the next feature
setting.
CALL TONE SELECTION
Your GXT600/650 Series has 5 selectable CALL TONES. To select,
press the MENU button until a “CA” icon appears and to the right of
the “CA” icon the current CALL TONE setting is displayed. Then press
the buttons to make the CALL TONE selections - the radio will
emit a corresponding tone for each selection. To confirm, press the
PTT button or press MENU button to move to the next feature setting.
Note : GXT650 has 5 “Animal Sound” CALL Tones.
VIBRATE ALERT
To turn the VIBRATE ALERT on, press the MENU button nine times
so the display will show the VIBRATE-ALERT icon blinking, while on
the right of the CHANNEL NUMBER, an “oF” icon appears. Select
“on” by pressing the buttons and push the PTT button, or press
MENU button again to move to the next feature setting. The VIBRATE
ALERT icon will remain on the display.
To turn the VIBRATE ALERT off, press the MENU button nine times,
so the display will show the VIBRATE ALERT icon blinking, while on
the right of the CHANNEL NUMBER, an “on
” icon appears. Select
“oF” by pressing the buttons and push the PTT button, or press
MENU button to move to the next feature setting. The VIBRATE
ALERT icon will go off.
To Next Page
Loading...
Need help?
General
