11
Beep (Keypad)
Every time a button is pressed, you will hear a Beep tone.
To enable/disable the beeps, follow this procedure:
1. Press the MENU button.
2. Turn the CH +/- knob until BEEP is displayed.
3. Push ENTER to enter the function.
4. Turn the CH +/- knob to activate/deactivate the Beep tones.
5. Confirm your selection with ENTER.
6. Push the BACK key to exit the menu.
VOX
The VOX feature enables hands free conversations without using the PTT key. Just speak
in the direction of the microphone and the communication will be automatically activated.
The VOX sensitivity can be adjusted in 10 different levels (0,1,2,3…9) through the Menu or
programming software.
OFF means that the VOX is turned off, level 9 has the lowest VOX sensitivity.
To activate the VOX levels:
1. Press MENU.
2. Rotate the CH +/- knob till the display shows VOX.
3. Enter the function by pushing the ENTER key.
4. Rotate the CH +/- knob again to select the desired VOX level: 9= lowest sensitivity, 1=
highest sensitivity.
5. Confirm your selection by pushing ENTER.
6. Push BACK to exit the menu.
VOXTIM (Vox Delay Times)
This function allows to set a delay at the end of hands-free (VOX) transmission to let
people finish their conversation before returning to Rx mode.
1. Press MENU.
2. Rotate the CH +/- knob until the display shows VOXTIM.
3. Press ENTER to enter the function.
4. Rotate the CH +/- knob again to set the desired delay time (from 0.5 to 3 seconds).
5. To confirm press ENTER.
6. Press BACK to exit the MENU.
SCAN (Scan Modes)
To set the SCAN mode follow these steps:
1. Press MENU and rotate the CH +/- knob until the display shows SCAN.
2. Press ENTER and rotate the CH +/- knob to select the type of scan mode (TO/CO/ SE).
TO - Time-operated Scan
Whenever a signal is detected, the radio will suspend the scan for 5 seconds and then will
continue to scan even if the signal is still present.
CO: Carrier-operated Scan
To Next Page
Loading...
