Midland XT511A - VOX (Hands-Free Transmission); Silent Operation; Roger Beep (End of Transmission) Tone

Model XT511A Series
Page 15
midlandusa.com
When the Battery Meter drops to 1 bar , the TX Power will
automatically switch from Hi(H) to Lo(L) level.
Note : You cannot adjust the power setting on the FRS
channels (8~14). They are set to Low power per FCC
regulations.
VOX (Hands-free Transmission)
Your radio has 9 VOX level settings: (oF/1~9).
To turn the VOX on, press the MENU button until a “Vo” appears,
while on the right, the “oF” setting appears. Turn the TUNING knob
to make the VOX setting selections. To confirm, push the PTT key or
press the MENU button again to move to the next feature setting.
VOX will be more sensitive on the “1” setting than on the “9” setting.
To turn the VOX off, press the MENU button until a “Vo” appears,
while on the right, the current VOX setting appears. Select “oF” by
turning the TUNING knob. To confirm, push the PTT key or press the
MENU button again to move to the next feature setting.
Note: For VOX Hands-free operation use Midland headset
accessories or built-in internal microphone. The
accessory hand mic is also intended for VOX mode use.
SILENT OPERATION
Your radio has a SILENT OPERATION mode. In this mode, all
“beeps” and “tones” are disabled.
To set the SILENT OPERATION, press the MENU button until the
display shows a “bP” icon. Select “on” or “oF” by turning the TUNING
knob. To confirm, push the PTT key or press MENU button to move
to the next feature setting.
When the SILENT OPERATION is off, the icon will appear on the
display.
ROGER BEEP (End of Transmission) TONE
When the PTT button is released, the radio will beep to confirm to
other users that your transmission has finished.
To set the ROGER BEEP tone, press the MENU button until the
display shows an “rb” icon. Select “on” or “oF” by turning the
TUNING knob.
!