XT70 PRO user’s manual | 9
With the ▲/▼ buttons select “bl on” and confirm by pushing PTT or wait for
4 seconds.
Keypad lock
Keep pressed CALL/ for about 3 seconds and will be displayed as confir-
mation. Only PTT and CALL/ remain active. To disable this function, keep
pressed again CALL/ for 3 seconds approx.
Power Save
The battery power saving feature enables a reduction in the consumption of up
to 50%; power saving comes on automatically when the transceiver does not
receive any signal for more than 5 seconds. When the batteries are discharged,
bt LO appears on the display: recharge the battery pack.
MENU button
Alarm function (Emergency)
Keep pressed the MENU key for 3 seconds. The radio will switch to Alarm
Emergency mode.
XT70 PRO will switch to transmission for 30 seconds by generating a sound
alarm which will be heard for the first 10 seconds of the transmission.
Then for the remaining 20 seconds it will remain in tx so as to allow the user to
communicate his status.
In the following 20 seconds, the radio will switch to reception.
This sequence is automatically repeated for 3 times.
At the end, the radio will switch to rx mode.
If needed, the emergency call can be repeated.
The Emergency function can be interrupted whenever you want, just press
shortly MENU or PTT.
Channel selection
Press once the MENU button. The number of the channel will start flashing on
the display. Press the scroll buttons ▲/▼ to scroll up or down the PMR and
then LPD channels till you select the desired channel.
Press the PTT button to confirm, or wait for 7 seconds.
Refer to the table of frequencies.
To Next Page
Loading...
