Midland XT70 PRO - Call Function

XT70 PRO user’s manual | 11
• 9 = low sensitivity (useful in very noisy areas or if you talk loudly)
All these options can be selected on two levels as follows:
1. To activate VOX function press the MENU button till VOX will appear
on the display.
2. Use the scroll ▲/▼ buttons to select the desired setting:
OFF: Disabled;
3. 1,2,3,4,5,6,7,8,9. Level 1 is the most sensitive
4. Press PTT to confirm or wait for 5 seconds.
To disable the VOX function follow the instructions above and select option oF.
ROGER BEEP (End transmission tone)
When your transmission is finished (PTT released), XT70 PRO gives out a
sound that indicates to the other party that s/he can start talking. This function
is enabled by default.
To deactivate it:
1. Press the MENU button until the display shows “rb on”;
2. Using the scroll buttons ▲/▼ select “o” and “rb of” will be displayed;
3. To confirm the roger beep deactivation, press PTT button or wait for 5
seconds.
CALL function
XT70 PRO can send 10 dierent call tones. To send this audio signal to other
users, press the CALL/ key.
To select the call tones:
1. Push the MENU button 6 times, until the display shows “CA 1”.
2. By pushing ▲/▼ you will hear the 10 pre-set melodies.
3. Confirm by pressing the PTT key or wait for 5 seconds.
Now, each time your XT70 PRO sends out a tone call, it will beep with the
selected melody.
Keypad beep
To deactivate the keypad beep, follow these steps:
1. Press MENU button, until “bP on” is displayed.
2. Use the ▲/▼ buttons until the display shows “bP of”.
3. Confirm by pushing the PTT or wait for 5 seconds.
Now you won’t hear any beep at the pressure of any button.