Midland XT70 PRO - Vibra-Call Function; Dual Watch; Squelch Adjustment

XT70 PRO user’s manual | 13
This unit set on one of these baby channels, should be placed near the baby;
while the one used for listening to the baby should be set on the sitter channels
“p” (from s1 to s9).
In the baby channels you can set with the MENU button the VOX sensitivity
level from 1 (highest sensitivity) to 9 (lowest sensitivity). See par. “VOX fun-
ction”.
With the MENU button it is also possible to change the baby or sitter channel
and select the high (H) or low (L) power.
In order to have the baby-sitter function properly operating, the 2 radios must
be set on the same frequency band (same channel and same CTCSS tone).
For example: if the radio place near the baby is set on the channel b1, the other one
used for listening to the baby should be set on channel s1.
To momentarily display the PMR446 channel and the sub-audio tone of the
Baby sitter channel, go to the desired channel and keep pressed the ▲ button
for 5 seconds.
Vibra-Call function
XT70 PRO is equipped with the “Vibra-Call” feature, which provides a silent
alert for incoming calls.
To activate this feature, press the MENU button until the display shows .
Use the ▲▼ buttons to disable or enable this feature (on: enables, oF:disables).
Push PTT to confirm or wait for 5 seconds.
Dual Watch
This function allows the monitoring of 2 channels at your choice.
Procedure:
1. Select one of the 2 channels you want to monitor.
2. In the PMR band, press the MENU button for 10 times till the display
shows “oF du”.
3. Select the second channel to monitor with the ▲/▼ controls.
4. Press PTT or wait for 5 seconds for confirmation.
5. To stop Dual Watch, push MON/SCAN
Squelch adjustment
This function allows to adjust the squelch in 9 dierent levels:
Level 1 has the lowest squelch, level 9 has the highest level of squelch.