• 29 •
Chapter 9: Truck info
IWith update software it is possible to turn the Passenger car software into a combined Passenger car
/ Truck version. You can contact Midtronics for further information.
Specifi cs for the Truck version:
This software is capable of testing batteries > 115Ah. At the same time it’s possible to test the 2
batteries in the 24V system one after the other.
Battery test
In our case the batteries >115Ah are always of the fl ooded type and therefore you will not be asked
to enter the battery technology.
When testing in vehicle you will get the question if you are testing a single battery or the complete set
of two. When you test two batteries it’s only necessary to enter the parameters once. After testing the
fi rst battery you will be asked to connect to the second battery. All the previous data is stored and at
the end compaired as a total set.
Balance test
In the balance test both batteries are tested and compaired to each other. When you select the
GENERATE PAIR option it’s always important to test the fi rst battery as GOOD BATTERY. The tester
will indicate what to do further.
Chapter 9: Truck info
To Next Page
Loading...
Need help?
General
