Midtronics inCHARGE 940 - MANUAL CHARGING MODE

- 11 -
6. CHOOSE TEST: Select IN VEHICLE or OUT OF VEHICLE.
NOTE: It is recommended to remove the battery from the vehicle before charging to avoid
damage to the vehicle electrical system and to charge in the chamber whenever possible.
7. BATTERY TYPE: Select REGULAR or SPECIAL (AGM).
8. CHOOSE TEST TYPE: Select WARRANTY, 48-HOUR CHECK, or OTHER.
If WARRANTY or 48-HOUR CHECK:
Select the battery DIN rating value (Table 1). (If the battery’s DIN rating is unavailable,
select OTHER.)
If OTHER:
a) Select a rating system (Table 1).
b) Select the battery rating (Table 1).
9. The inCHARGE940 will test the battery and display one of three results in Table 2 (with the
approximate charge time, if required).
a) Select the time required to charge the battery (in half-hour increments from 0.5
to 10 hours).
b) Select the rating system (Table 1).
c) Select the battery rating (Table 1). The inCHARGE940 will begin charging the
battery for the selected length of time.
Deutsche Industrie-Norm
Europa-Norm
International Electrotechnical Commission
European labeling of CCA
Cold Cranking Amps, as specified by SAE. The most common
rating for cranking batteries at 0 ºF (–18 ºC).
Japanese Industrial Standard: (shown on a battery as a
combination of numbers and letters, for example: 80D26)
Rating
System
100 to 1000 A
100 to 1700 A
100 to 1000 A
100 to 1700 A
100 to 1700 A
DIN
EN
IEC
SAE
CCA
Description
Value Range
Table 1: inCHARGE940 Battery Rating Systems and Value Ranges
JIS
43 values from
26A17 to 245H52
If you select MANUAL:
NOTE: A test code is unavailable if you charge the battery using Manual mode.
CAUTON: Before charging, make sure that the clamps are connected
to the battery. Charging in Manual mode without the clamps connected to
a battery may cause sparks, fire, or personal injury.
!