Midtronics Inc. 7000 Monroe Street Willowbrook, IL 60527
4
General Safety Guidelines xRC-3363
• Ensure that the AC power line ground is connected properly to the xRC-3363 input connector
or chassis. Similarly, other power ground lines including those to application and maintenance
equipment must be grounded properly for both personnel and equipment safety.
• In normal operation, the operator does not have access to hazardous voltages within the chas-
sis. However, depending on the user’s application conguration, HIGH VOLTAGES HAZARDOUS
TO HUMAN SAFETY may be normally generated on the output terminals. The customer/user
must ensure that the output power lines are labeled properly as to the safety hazards and that
any inadvertent contact with hazardous voltages is eliminated.
• This xRC-3363 is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been given supervision
or instruction concerning use of the xRC-3363 by a person responsible for their safety.
Risk of explosive gases.
Batteries may generate explosive gases. To reduce risk, follow these
safety instructions and those published by the battery manufacturer
and OEM. Failure to follow these instructions may result in personal
injury or death.
1.1 To reduce risk of battery explosion, follow these safety instructions and those published by the
battery manufacturer and the manufacturer of any equipment you intend to use in the vicin-
ity of a battery. Review cautionary marking on these products and on the engine, and on the
vehicle or equipment containing the battery.
Charging a non-rechargeable battery may
cause the battery to burst.
Only charge batteries for which xRC-3363 has been
designed and is intended for use. Failure to follow these
instructions may result in personal injury or death
If you are uncertain as to the type of battery you are attempting to charge, or the
correct procedure for checking the battery’s state of charge, contact the seller or battery
manufacturer.
1.2 Use of an attachment not recommended or sold by the xRC-3363 manufacturer may result in a
risk of re, electric shock, or injury to persons.
1.3 To reduce risk of damage to the electric plug and cord, pull by the plug rather than by the cord
when disconnecting the xRC-3363.
1.4 Do not operate the xRC-3363 if it has received a sharp blow, been dropped or otherwise dam-
aged in any way; contact Midtronics (see contact information on back cover).
1.5
Do not disassemble the xRC-3363; when repair is required contact
nearest Midtronics regional
oce
(see back cover of this manual for locations and contact information). Incorrect reassem-
bly may result in a risk of electric shock or re.
1.6 To reduce risk of electric shock, unplug the xRC-3363 from the AC outlet before attempting any
maintenance or cleaning. Turning o the controls will not reduce this risk.
1.7
Connect and disconnect the battery leads only when directed to do so by the xRC-3363.
1.8
Do not overcharge the battery (See Section 3).
1.9
Charge the battery in a dry, well-ventilated area.
1.10
Never place articles on or around the xRC-3363, or locate the xRC-3363 in a way that will restrict
the ow of cooling air through the cabinet.
1.11
An extension cord should not be used with xRC-3363.
1.12
Have a damaged cord or plug replaced immediately.
To Next Page
Loading...
Need help?
General
