Problem solving guide
87
Problem Possible cause and remedy
F73 or
Check the brew unit
The brew unit cannot be positioned correctly.
Switch the machine off with the On/Off sensor.
Remove and clean the brew unit (see "Cleaning
and care – Brew unit").
Push the coffee ejector of the brew unit into the
correct position (see diagram).
Do not fit the brew unit. Close the appliance door
and switch the machine on with the On/Off
sensor.
This will initialise the brew unit motor and put it back
into the start position.
When Insert the brew unit appears in the display,
open the appliance door and put the brew unit
back in the machine. Then close the door.
F233 The cup sensor is not inserted or is incorrectly
inserted.
Confirm the message with OK.
Switch the machine off with the On/Off sensor.
Insert the cup sensor.
Switch the machine on with the On/Off sensor.
To Next Page
Loading...
