Cleaning and care
56
Twist the upper section with the
holder for the milk pipework and pull
it off. Then pull the Y-shaped piece
off. Remove the dispensing spouts
.
Clean all parts thoroughly.
Clean the surfaces of the main
dispenser with a damp cloth.
If the milk pipe is blocked, clean it
under running water with the brush
supplied:
Insert the brush in the tube and move
it back and forth as far as it will go
until all milk residue has been
removed.
Fit the dispensing unit back together.
Push the dispensing unit back onto
the main dispenser. Press firmly to
ensure the spouts at the bottom
connect correctly with the edge of the
dispenser.
Replace the stainless steel cover and
connect the milk pipe if applicable.
To Next Page
Loading...
