General
To avoid the risk of damaging the
hob fit the wall units and extractor
hood before installing it.
~
The veneer or laminate coatings of
worktops (or adjacent kitchen units)
must be treated with 100 °C
heat-resistant adhesive which will not
dissolve or distort.
Any backmoulds must be of
heat-resistant material.
~
This appliance must not be used in
a non-stationary location (e.g. on a
ship).
~
The hob may only be installed
above a Miele oven if the worktop is at
least 40 mm thick.
~
Observe carefully the safety
distances given on the following pages.
~
After installation, ensure that the
connection cable is without hindrance
and that there is no mechanical
obstruction which could damage it,
such as a drawer.
~
This appliance must not be installed
over a dishwasher, washing machine,
tumble dryer, refrigerator or freezer.
The high temperatures radiated by the
hob could damage the appliance
below.
All dimensions in this instruction booklet
are given in mm.
Safety instructions for installation
33
To Next Page
Loading...
Need help?
General
