Installation
Make sure power is not supplied to
the appliance while installation or
maintenance work is performed.
Disconnect the power supply to the
work area by unplugging the unit,
tripping the circuit breaker or
removing the fuse. The coffee
system must be properly installed
before being used.
^
Plug the appliance into the electrical
outlet.
^ If you have a cabinet with
3
/
4
"
(19 mm) side panels, you have to drill
four holes first.
– Center the machine in the
cabinet.
– Tighten the screws just so they
leave a mark in the panel.
– Remove the machine from the
cabinet and drill four holes
1
/
16
"
(2 mm) with a diameter of
3
/
16
"
(4.5 mm).
^
Level the machine with the four
height adjustable feet.
The feet can be turned out up to
3
/
8
"
(10 mm).
^
Push the appliance all the way back
into the cabinet.
^
Open the door and partially tighten
the screws by hand. Do not use an
electric screwdriver.
^ Carefully turn the lower screws to
center the machine.
^ To fix the machine in the cabinet,
tighten the upper screws.
Installation
61
www.dexpress.com Page 70 of 105 12/31/2010
www.dexpress.com Page 70 of 105 12/31/2010
CVA2650
CVA2650
Mfr Sup
Mfr Sup
To Next Page
Loading...
