The descaling procedure will not start for another 5
minutes or so. This time is needed to allow the descaling
tablets to dissolve fully in the water. It will take longer than
this to start if the appliance is too warm.
During descaling a little water and descaling agent will run
out of the coffee and steam spouts. This is followed by an
activation period, before more descaling agent is drained out,
and so on. A message will appear in the display letting you
know approximately how long this procedure will take.
^
When a message asking you to fill the water container
with fresh tap water appears in the display, you should
remove the container and rinse it thoroughly with clean
water. Make sure all traces of descaling agent are
removed, and then fill it up the the k mark with clean tap
water.
Empty the waste container at the same time.
Water will flow out of both spouts during the rinsing process.
The drip tray will need to be emptied several times during
this process.
When descaling has been completed, Programme finished
will appear in the display.
The machine will run another brief rinsing programme, and is
then ready for use again.
Descaling when not prompted by a message
If you want to carry out descaling before being prompted to
do so by the machine:
Descale
K1 K2 K3 K4 K5 L onG
k
C
^
Select "Descale" with one of the arrow sensors.
^
Touch the OK sensor to start the descaling programme.
Descaling the machine
67
To Next Page
Loading...
