Cleaning and care
34
Cleaning the drawer front and
glass lid
Remove soiling and fingerprints with
a standard domestic glass cleaner or
with a clean, damp microfiber cloth.
After cleaning, wipe the surfaces dry
using a soft cloth.
Cleaning the vacuum chamber
and sealing bar
Damage caused by liquids.
Liquid getting into the vacuum pump
air-intake valve can result in damage
to the vacuum pump.
Take care that liquids do not get into
the air-intake valve.
Tip: To make cleaning easier, the seal-
ing bar can be lifted out.
Remove soiling immediately using a
solution of hot water and liquid dish
soap applied with a clean sponge or
use a clean, damp microfiber cloth.
Remove any residual cleaning agent
with some clean water.
After cleaning, wipe the surfaces dry
using a soft cloth.
Cleaning the vacuum adapter
Clean the vacuum adapter with a
clean sponge and a solution of hot
water and liquid dish soap or a clean,
damp microfiber cloth.
Then dry the vacuum adapter with a
cloth.
Do not use the vacuum adapter again
until it is completely dry.
Cleaning the vacuum-sealing
bag support
Clean the vacuum-sealing bag sup-
port with a clean sponge cloth, liquid
dish soap, and warm water or with a
clean, damp microfiber cloth.
Then dry the vacuum-sealing bag
support using a cloth.
Do not use the vacuum-sealing bag
support again until it is completely
dry.
To Next Page
Loading...