Before you begin
Read these instructions completely
and carefully.
Have the appliance installed by a
qualified technician, according to
the enclosed installation instructions.
To reduce the risk of injury or
damage to the product, two people
should be used for installation.
These installation instructions are
intended for use by qualified installers.
In addition to these instructions, the
appliance must be installed in
accordance with all local codes, or in
the absence of a local code.
– In the USA, in accordance with the
National Electric Code,
ANSI/NFPA 70 - latest edition/State
and Municipal codes and/or local
codes.
–
In Canada, in accordance with the
Canadian Electric code C22.1 - latest
edition/Provincial and Municipal
codes and/or local codes.
Tools needed for installation
–
Cordless screwdriver
–
Torx screwdriver
–
Hammer drill
–
Wood drills in different sizes
–
Hammer
–
rachet 5/16" (8 mm)
–
Adhesive tape
–
Multi-grip pliers
–
Level
– Tape measure
– Square
When fastening the cabinet to the wall
behind it (see "Installing the appliance")
use:
– suitable plugs/screws depending on
the type of wall.
– several mounting brackets, if required.
Other
–
Stepladder
–
Dolly, hand truck
–
Wooden beam (cross section
min. 3" x 4" [75 mm x 100 mm] as an
alternative tilt protection, length
depends on the width of the
installation cavity)
–
Wood screws in different sizes
Optional accessories
–
"Merging Kit" for side-by-side installation
–
RemoteVision module for wireless
monitoring
Installing the appliance
60
To Next Page
Loading...
Need help?
General
