Miele FNS 28463 E ed/cs - Setting the Display Brightness; Setting the Temperature Unit °C;°F; Switching Demo Mode  off; Resetting to the Factory Default Settings

Selecting further settings
38
Setting the display brightness
You can set the display brightness in
the segment bar:
If all segments are filled in, the
maximum brightness is selected.
You will see the brightness change as it
is being adjusted.
Setting the temperature unit°C/°F
You can choose between degrees
Celsius°C and degrees Fahrenheit°F
for the temperature display.
Switching Demo mode off
Demo mode allows the refrigeration
appliance to be presented in the
showroom without the cooling system
being switched on. Do not activate
this setting for domestic use.
If Demo mode has been switched on as
a default setting, will show on the
display. You can switch the function off
here.
If Demo mode has been switched off it
cannot be switched on again via
Settings mode.
Resetting to the factory default
settings
All appliance settings are reset to the
factory default and the appliance is
switched off.
Accessing information
Appliance data (model number and
serial number) is shown in the display.
Tip: This data is important when
reporting an appliance fault to Miele
Service.
Confirm with OK to leave the
information screen.
–Displaying licence agreements
Licences used can be displayed via ©.