Miele G 4263 VI Active - Adding Salt

Before using for the first time
23
Adding salt
Important! Before filling the salt
reservoir with dishwasher salt for the
first time, you must fill it with approx.
2 litres of water to enable the salt to
dissolve.
Once the dishwasher has been used,
there is always sufficient water in the
reservoir.
 Remove the lower basket and un-
screw the salt reservoir cap.
Water or saline solution will run out
of the reservoir when the cap is re-
moved.
It should therefore only be removed
in order to refill the salt reservoir.
 Fill the reservoir with approx. 2 litres
of water (first use only).
 Place the funnel provided over the
salt reservoir and carefully fill with salt
until the reservoir is full. The salt
reservoir holds approx. 2kg of salt
depending on the brand used.
 Clean any excess salt from around
the reservoir opening and then screw
the cap on again firmly.
 Immediately after filling the salt reser-
voir, run the Gentle programme
with the Turbo option and without
any crockery in the dishwasher to re-
move any traces of salt from the cab-
inet.