Miele G 4700 - Setting the Rinse Aid Dosage

Before using for the first time
28
Setting the rinse aid dosage
You can adjust the rinse aid dosage for
best r
esults.
The rinse aid dosage can be set from
appr
ox. 0-6 ml. It is set to a recommen‐
ded setting of approx. 3 ml at the facto‐
ry.
If the function to adjust the Sensor
wash pr
ogramme has been activated,
the amount of rinse aid dispensed in
the Sensor wash programme can be
higher than that set.
If spots appear on crockery and glass‐
war
e:
 Incr
ease the rinse aid dosage.
If clouding or smearing appears on
cr
ockery and glassware:
 Dec
rease the rinse aid dosage.
 Switch the dishwasher off with the 
butt
on, if it is switched on.
 P
ress the Start button in and whilst
holding it in switch the dishwasher
on using the  On button
Keep the Start button pressed in for
at least four seconds until the Start
indicator light comes on.
If this does not happen, start the proce‐
dur
e from the beginning again.
 P
ress the  button 3 times.
The  indicat
or will flash rapidly 3
times at intervals.
The dosage set will show in the display
aft
er the  symbol.
The factory default setting of   will
appear in the disp
lay.
This indicates a setting of 3 ml.
 If
you wish to change this setting use
the Start button.
Each press of the button moves you
up a level. When the highest rinse aid
level is reached, the setting starts
from the beginning again.
The setting is now stored in memory.
 Switch the dishwasher off with the 
butt
on.