Programme options
52
Optimise standby
"Optimise standby" is activated by de‐
fault.
To save energy the dishwasher will
sw
itch off automatically a few minutes
after the last time a button has been
pressed or after the end of a pro‐
gramme.
The dishwasher will not switch off
whilst a pr
ogramme is running, during
the Delay start period or if there is a
fault.
Optimise standby can be switched off if
you pr
efer. If you do this the duration
before the dishwasher switches off in‐
creases to 6 hours. Doing this will in‐
crease energy consumption.
Switch the dishwasher off with the
butt
on, if it is switched on.
P
ress the Start button in and whilst
holding it in switch the dishwasher
on using the On button
Keep the Start button pressed in for
at least four seconds until the Start
indicator light comes on.
If this does not happen, start the proce‐
d
ure from the beginning again.
P
ress the button 8 times.
The indicat
or will flash rapidly 8
times at intervals.
The flashing sequence in the display
shows whether Optimise standby is ac‐
tivat
ed or not.
– : "O
ptimise standby" is activated
– : "Optimise standby" is switched
off
P
ress the Start button to change the
setting.
The setting is now stored in memory.
Switch the dishwasher off with the
butt
on.
To Next Page
Loading...
