Problem solving guide
65
Water inlet fault
Problem Cause and remedy
The Inle
t/Drain check
indicator flashes on and
off.
The stopcock is closed.
O
pen the stopcock fully.
The dishwasher stops
durin
g a programme.
The Inlet/Drain check
indicator flashes.
Fault code or ap‐
pears in the display.
Before rectifying the problem:
Switch the dishwasher off with the b
utton.
The water intake is restricted.
Op
en the stopcock fully and start the programme
again.
Clean
the water inlet filter (see "Maintenance").
The wat
er pressure at the intake is lower than 30
kPa (0.3 bar).
Seek professional advice.
To Next Page
Loading...
