Programme options
49
If optimise standby is switched on
(see "P
rogramme options, Optimise
standby") the display will go out after
a few minutes, leaving just the Start
indicator flashing slowly.
Press any button to switch the display
back on aga
in for a few minutes.
The time up until the programme starts
will show counting up in the display in
hou
rs for durations above 10 hours,
and in minutes for durations below this.
When the set time is reached, the pro‐
gr
amme selected will start automatical‐
ly. The time remaining will appear in the
display and the indicator light will go
out.
How the Delay start time is shown in
the display:
up to 59 minutes:
e.g. 30 minu
tes = .
1 hour up to 9 hours 30 minutes:
e.g. 5 hours =
.
over 10 hours:
e.g. 15 hours =
Starting a programme before the De‐
la
y start period has elapsed:
A programme can be started before the
D
elay start period has elapsed.
Proceed as follows:
Switch the dishwasher off with the
b
utton.
Switch the dishwasher on again with
the
button.
Select the pr
ogramme you want.
P
ress the Start button.
The programme will begin and the S
tart
indicator light will light up.
To Next Page
