Miele's RemoteVision Wi-Fi technology
creates a 'virtual link' between your
appliance and our monitoring center. If
a fault occurs, Miele's client service
center will be notified and contact you,
or another trusted individual identified
on your call roster, in order to gain
access to your appliance to fix the
problem.
For information on set-up and
installation of the RemoteVision module,
see the separate RemoteVision
installation manual.
Be sure your wireless system meets the
following requirements
–
A wireless router that supports an
IEEE 802.11b protocol
–
Windows XP
®
or newer operating
system, Mac
®
OS X 10.3 or higher
–
Cable or DSL modem
–
Microsoft
®
Internet Explorer 6 or
higher, Safari 2.0 or higher, Firefox
1.5 or higher
* Please note that each wireless router
manufacturer supplies their own
device drivers and setup programs.
Due to the differences in
manufacturers, exact router setup
instructions are not included in this
manual. Wording and instructions
may vary.
RemoteVision
56
To Next Page
Loading...
