Miele G 6300 - Water Inlet Fault

Problem solving guide
72
Water inlet fault
Problem Possible cause and remedy
One of the following
messages appears in
the display:
 Open stopcock
The tap is turned off.
 T
urn on the tap fully.
 Water intake
Before rectifying the problem, you must:
 Switch the dishwasher off with the  butt
on.
Water intake is restricted.
 T
urn on the tap fully and start the programme
again.
 Clean
the water inlet filter (see "Maintenance").
 The wat
er pressure at the intake is lower than 30
kPa (0.3 bar).
Seek professional advice.
The following message
appears in the display
during the SolarSave pr
o‐
gramme:
 Intake temp. low
The intake water has not reached the required tem‐
pe
rature of 45°C (see "Water connection - Connec‐
tion to the water supply").
 S
tart the programme again.
 If the fault message appears again, select a differ‐
en
t programme.