Operation
47
Switching on the dishwasher
Make sure the spray arms can rotate
freely.
Close the door.
Open the stopcock, if it is closed.
Press the button.
The programme selected will briefly ap-
pear in the display and the indicator
light for the programme selected will
come on.
Next, the estimated energy and water
consumption may be shown for the
chosen programme for several
seconds.
Then the display will show the estim-
ated duration for the selected pro-
gramme.
The Start indicator light will flash.
Switch on the Memoryfunction (see
“Settings” chapter, “Memory” section)
if you want the last programme selec-
ted to remain selected instead of the
ECOprogramme. This may increase
energy consumption.
Selecting a programme
Choose your programme according to
the type of load and the degree of soil-
ing.
The different programmes and their
uses are described in the “Programme
overview” chapter.
Use the programme selection but-
ton to select the programme you
want.
The indicator light for the programme
selected will come on.
Further programmes can be selected
via the option.
Use the programme selection but-
ton to select the option.
The first of the further programmes will
appear in the display.
Use the buttons in the display to
select the programme you want.
You can now select programme options
(see “Programme options” chapter).
If any programme options are selected,
the appropriate indicator lights will also
light up.
To Next Page
Loading...
