Miele G 7100 SCI - Installation; The Miele Waterproof System; Water Inlet

Installation
-
I
N
-
S
T
A
L
L
-
A
-
T
I
O
N
-
82
The Miele Waterproof system
Provided that your dishwasher has
been installed correctly, the Miele Wa-
terproof system will protect you from
water damage throughout its lifetime.
Water inlet
 Danger to health due to wash
water.
Water in the dishwasher is not drink-
ing water.
Do not drink any water from the dish-
washer.
 Health risk and risk of damage
due to contaminated inlet water.
The quality of the incoming water
must correspond to the drinking wa-
ter specification of the country in
which the dishwasher is being oper-
ated.
Connect the dishwasher to a drinking
water supply.
The dishwasher may be connected to
cold or hot water (up to max. 65°C)
supplies.
If energy-saving water heating sources
such as solar energy circulation sys-
tems are used, we recommend connec-
tion to the hot water. This saves both
time and electrical energy costs. Hot
water is used in all programmes.
The SolarSaveprogramme (if available)
requires a hot water connection of
between a minimum of 45°C and a
maximum of 65°C (inlet temperature).
The higher the water inlet temperature,
the better the cleaning and drying res-
ults.
The inlet hose is approx. 1.5m long. A
1.5m long, flexible metal extension
hose (tested to 14,000kPa/140bar) is
available as an optional accessory from
Miele specialist retailers or the Miele
Customer Service Department.