Problem solving guide
97
Problem Cause and remedy
Increase the dispensing quantity during automatic
dispensing (if available) (see “Settings – AutoDos”).
Add more dishwasher salt.
Plastic items are discol-
oured.
Natural dyes, e.g. from carrots, tomatoes or ketchup
may be the cause. The amount of detergent used or
its bleaching effect was not sufficient to deal with
natural dyes.
Use more detergent (see “Detergent”).
Parts that are already discoloured will not revert to
their original colour.
There are rust stains on
cutlery.
The affected items are not corrosion-resistant.
No remedy.
Purchase cutlery that is dishwasher-proof.
A programme was not run after dishwasher salt was
added. Traces of salt have got into the normal wash
cycle.
Immediately after filling the salt reservoir and each
time you remove the salt reservoir cap, run the
Rinse salt programme without load items in the
dishwasher to dissolve and remove any traces of
salt from the wash cabinet.
The salt reservoir cap has not been screwed on cor-
rectly.
Replace the cap, making sure that it screws back
on correctly.
To Next Page
Loading...
