Technical Information
105
G 600/G 800
5. After selecting options, press the Start/Stop button twice and turn the
dishwasher off.
Program button Function Options Display
Normal 130
Water hardness
setting
0 gpg
1 - 36 gpg
2
90
91
Normal 150 Buzzer
On
Off
40
41
Table 6-36: G 890 Programming Functions
1
If “0” is displayed, the dishwasher is programmed for “without water softener”. To change to “with
water softener”, follow the steps in Service Mode 2 (6.8.7.3).
2
Factory setting
6.8.7.1.1 Setting the Water Hardness
1. Measure the water hardness in grains per gallon (gpg).
2. Access Programming Mode.
3. Press the Sani Wash button. Use the Top solo button to toggle through to the desired
water hardness amount.
4. To save: Press the Start/Stop button twice and turn the dishwasher off.
6.8.7.1.2 Checking the Water Hardness Level
1. Access Programming Mode.
2. Press the Sani Wash button.
3. The number in the display will indicate the programmed water hardness setting.
4. Turn the dishwasher off.
6.8.7.2 Service Mode 1
1. To access Service Mode 1, close the door and turn the dishwasher on. All
program lights should light. If not, press the Start/Stop button to cancel the
program. Turn the dishwasher off.
2. Press and hold the “+”and Top solo buttons while turning the dishwasher on.
Successful accessing of Service Mode 1 is indicated by the display showing a
dot (.) and a lit Drain light.
3. Select a program. The program duration will appear in the display.
4. Press the Start/Stop button to start the program. The display will show the
current program step.
5. Pressing the Start/Stop button repeatedly will allow the technician to advance
through the program. If the Start/Stop button is not pressed, the program steps
are carried out automatically, in their normal order.
6. Service Mode 1 will be canceled if the dishwasher is shut off or the door is
opened.
7. Service Mode 1 can be activated at any time during a wash cycle. When it is
activated during a program cycle, the display will show the current program step.
Note: The program chart in the wiring diagram should be used to follow the
machine functions when stepping through a program.
8. If the dishwasher door is opened and closed or the dishwasher is turned off and
on, the service mode will be canceled and the machine will continue to advance
normally.
To Next Page
Loading...
Need help?
General
