Technical Information
125
G 600/G 800
6.8.12.3.2 Deleting Stored Fault Codes
Access Programming Mode and press Start/Stop twice.
6.8.12.3.3 Operating Hours
1. Access Service Mode 2.
2. Press the appropriate program button indicated in Table 6-66 to display operating hours.
Program button Display
Sani Wash First 3 digits of total operating hours
Normal Plus Last 3 digits of total operating hours
Table 6-66: G 898 Operating Hours
Example:
Sani Wash: 007
Normal Plus: 127
Total operating hours: 7.127 hours
Incognito Models
6.8.13 G 803, G 643, G 843, G 663, G 863
(G 803 shown)
Programming Flow Chart
Enter Programming Mode
To access:
Water hardness settings
Heated drying
Increased water intake
Buzzer
Enter Service Mode 1
To access:
Manual step mode
Component test program
Enter Service Mode 2
To access:
Error messages
Program index
Increased water temperature selection
Water softener
Interim rinses
Dishwasher width setting
Table 6-67: G 803, G 643, G 843, G 663, G 863 Programming Flow Chart
6.8.13.1 Programming Mode
1. To access the Programming Mode close the door and turn the dishwasher on.
All program lights should light. If not, press the Start/Stop button to cancel the
program. Turn the dishwasher off.
2. Press and hold the 1 and 3 buttons while turning the dishwasher on. A blinking
Salt light indicates successful accessing of the Programming Mode.
3. To toggle functions on or off, press the appropriate program button (1 to 4)
indicated in Table 6-68 below to modify the corresponding function.
4. To save: After selecting options, press program button 6 twice and turn off the
dishwasher.
To Next Page
Loading...
Need help?
General
