Technical Information
114
G 600/G 800
Fault code Program light and
status
Rinse light
status
Fault
F08 Normal Plus Lit Flashing Water intake failure, heater level
switch
F09 Normal Lit Flashing Heater level switch not switching
on at the end of thermal stops
Table 6-49: G 892, G 832 Fault Code Chart
6.8.9.3.2 Stage 2
1. To access Stage 2 of Service Mode 2, close the door and turn the dishwasher on. The
Start/Stop light must be blinking. If the Start/Stop light is not blinking, press and hold
the Start/Stop button for at least 3 seconds to exit the cycle. The Start/Stop light should
now be blinking.
2. Press and hold the Start/Stop button while turning the dishwasher on. Release the
Start/Stop button and immediately press it 2 more times. Flashing Intake/Drain and Salt
lights indicate successful accessing of Service Mode 2.
3. Press the Top solo button once. Flashing Intake/Drain and Salt lights and a lit Drying
light indicate successful accessing of Stage 2 of Service Mode 2.
4. Use the Program Index chart (Table 6-50) to determine the electronic version.
5. To save, press the Top solo button twice.
Index Program button Status
P0 Pots & Pans Lit
P1 Sani Wash Lit
P2 Normal Plus Lit
P3 Normal Lit
Table 6-50: G 892, G 832 Program Indices
6.8.9.3.3 Stage 3
1. To access Stage 3 of Service Mode 2, close the door and turn the dishwasher on. The
Start/Stop light must be blinking. If the Start/Stop light is not blinking, press and hold
the Start/Stop button for at least 3 seconds to exit the cycle. The Start/Stop light should
now be blinking.
2. Press and hold the Start/Stop button while turning the dishwasher on. Release the
Start/Stop button and immediately press it 2 more times. Flashing Intake/Drain and Salt
lights indicate successful accessing of Service Mode 2.
3. Press the Top solo button twice. Flashing Intake/Drain and Salt lights and a lit End light
indicate successful accessing of Stage 3 of Service Mode 2.
4. Use the arrow buttons to scroll to the appropriate program function.
5. Use the Top solo button to change the status of the function.
6. To save, press the Start/Stop button twice.
Program Function Options Program light status
Pots & Pans Increase temperature
66 Flashing
72 Lit
Sani Wash Water softener
On Flashing
Off Lit
Normal Plus Interim rinses
1 rinse Flashing
2 rinses Lit
Normal Increase water level
Norm Flashing
Increase Lit
Economy Dishwasher width
24” Flashing
18” Lit
To Next Page
Loading...
Need help?
General
