Checking the programmed water
hardness
^
Turn off the dishwasher with the
“On/Off” button.
^
Turn the program selector to “Stop”.
^
Hold the “Start” button in and at the
same time turn the dishwasher on
with the “On/Off” button. With in
2 seconds release the “Start” button.
The “Salt” indicator flashes.
Note:
If any other indicators light or flash the
process must be repeated.
Except:
If the “Rinse aid” indicator lights rinse
aid was never added or needs to be re-
filled.
^ Turn the program selector slowly
past “Normal 55 °C/130 °F” to the
“8 o’clock” position.
The “Start” indicator will light when the
programmed water hardness setting is
reached. The water hardness level cor
-
responds to the position of the program
selector (see the table “Programming
and setting the water hardness level”).
^
Turn the program selector to “Stop”.
^
Turn off the dishwasher with the
“On/Off” button.
Before using for the first time
16
To Next Page
Loading...
