Checking the water level
If the water pressure is less than 15 psi,
not enough water will flow into the wash
cabinet.
^
To check the water level, open the
water valve completely and run the
“Rinse & Hold” program once (with-
out dishes), to bring water into the
system.
^
Run, the “Rinse & Hold” program
again. After approximately 3 minutes,
open the door and remove the lower
basket from the machine.
The water level is correct when dimen
-
sions “X” is at least 1/8” (4 mm).
If it measures less, the water intake time
must be increased (see the following
page).
Solving problems
48
To Next Page
Loading...
