Setting the rinse aid dosage
The rinse aid dosage can be set from
approx. 0-6 ml. It is set to a
recommended setting of approx. 3 ml
at the factory.
If spots appear on crockery and
glassware:
^
Increase the rinse aid dosage.
If clouding or smearing appears on
crockery and glassware:
^
Decrease the rinse aid dosage.
^ Switch the dishwasher off with the Off
button V.
^ Press the programme selector button
in, and whilst holding it in switch
the dishwasher on using the On
button U.
Keep the programme selector button
pressed in for at least four seconds
until the lower right hand programme
indicator comes on.
If this does not happen, start the
procedure from the beginning again.
^
Press the Turbo/Tab button three
times.
The Tab indicator light will flash briefly
three times at intervals.
p3will flash in the Time display.
This means that the rinse aid dosage
has been set to 3 ml at the factory.
The dosage set will show in the Time
display after the p.
^
Use the programme selector button
to select the rinse aid dosage you
want.
The dosage amount alters each time
you press the button.
The programmed rinse aid dosage is
now stored in memory.
^
Switch the dishwasher off with the Off
button V.
Before using for the first time
22
To Next Page
Loading...
