The dishwasher does not fill/drain
Problem Possible cause Remedy
The In-operation
indicator is flashing
quickly.
The buzzer is
sounding.
The Inlet/Drain
indicator flashes when
the door is open.
The tap is
closed.
–
Open the tap fully.
The dishwasher stops
during a programme.
The In-operation
indicator is flashing
quickly.
The buzzer sounds.
The Inlet/Drain
indicator flashes when
the door is open.
Fault code FXX shows
in the display.
Before rectifying the problem you
must:
– Switch the dishwasher off with
the Off button V.
Fault F12/F13:
Water intake is
restricted.
– Open the tap fully.
– Clean the water inlet filter (see
Maintenance).
– The water pressure at the intake
is lower than 30 kPa (0.3 bar).
Seek professional advice.
Fault F11:
Water outlet is
restricted, water
remains in the
wash cabinet at
the end of a
programme.
– Clean the filter combination. See
Cleaning and care.
–
Clean the drain pump. See
Maintenance.
–
Clean the non-return valve. See
Maintenance.
–
Remove any kink in the drain
hose.
Problem solving guide
52
To Next Page
Loading...
