Problem Possible cause Remedy
Detergent residue is
left in the dispenser
at the end of a
programme.
The dispenser was
still damp when
detergent was added.
Make sure the dispenser is dry
before adding detergent.
The detergent
dispenser lid cannot
be closed properly.
Clogged detergent
residue is blocking
the catch.
Clean the detergent from the
catch.
At the end of a
programme there is a
film of moisture on
the inside of the door
and the interior walls.
This is caused by the
drying system and
does not indicate a
fault.
The moisture will dissipate after a
short while.
Water remains in the
wash cabinet at the
end of a programme.
Before rectifying the problem you
must:
– Switch the dishwasher off with
the Off button V.
The filter combination
in the wash cabinet is
clogged.
Clean the filter combination. See
Cleaning and care.
The drain pump or
non-return valve may
be blocked.
Clean the drain pump or the
non-return valve. See
Maintenance.
The drain hose is
kinked.
Remove any kink from the drain
hose.
Problem solving guide
54
To Next Page
Loading...
