will appear in
the display.
The dishwasher does
not start or the Flexi‐
Timer stops running.
The safe mode of the dishwasher was activated.
The following takes place:
– If you do not close the door within four seconds
of the last press of a button at program start
– If the door is open for longer than four seconds
during a program or within the delay start time
ĺ Press the OK and close the door within four sec‐
onds.
Detergent residue is left
in the dispenser at the
end of a program.
The dispenser was still damp when detergent was
added.
ĺ Make sure the dispenser is dry before adding de‐
tergent.
The dispenser cover
cannot be closed.
Detergent residue is blocking the latch.
ĺ Remove the detergent residue.
The inside of the door
and/or the interior walls
are wet after a program
has finished.
This is caused by the drying system and does not in‐
dicate a fault. The moisture will dissipate after a
while.
Water remains in the
wash cabinet at the end
of a program.
Before fixing the fault:
ĺ Turn the dishwasher off with the ɩ button.
The filter system in the wash cabinet is clogged.
ĺ Clean the filter system (see "Cleaning and care -
Filter system").
The drain pump or non-return valve is blocked.
ĺ Clean the drain pump or the non-return valve (see
"Frequently asked questions").
The drain hose is kinked.
ĺ Remove the kink.
To Next Page
Loading...
