Correcting minor faults
Installation, maintenance and re-
pairs to the electrical components
of this appliance should only be car-
ried out by a suitably qualified and
competent person in accordance
with local and national safety regula-
tions. Repairs and other work by un-
qualified persons could be dan-
gerous. The manufacturer cannot
be held responsible for unauth-
orised work.
Some minor problems however can be
dealt with as follows:
What to do if . . .
. . . the hob cooking zones / hot-
plates do not warm up after being
switched on.
Check whether,
the mains fuse has blown. Contact a
qualified electrician or the Miele Ser-
vice Department.
. . . the oven does not heat up.
Check whether,
the selector switch is set to the func-
tion required, and the temperature
control is set at the correct tempera-
ture.
"AUTO" is lit up in the timer display
field.
To switch on the oven independently
of the timer, "@" should show in
the display. Press the "i" button.
the mains fuse has blown. Contact a
qualified electrician or the Miele Ser-
vice Department.
. . . the heating works, but not the
oven lighting.
The bulb needs changing:
Disconnect the appliance from the
electricity supply:
Switch off at the isolator or the mains
fuse box.
Unscrew the light cover and the seal.
Change the bulb:
230-240°V, 25 W, E 14, heat
resistant to 300°C.
Screw the light cover and the seal
back on again.
Reassemble in the reverse order, care-
fully ensuring all parts are correctly in
place.
Correcting minor faults
58
To Next Page
Loading...
