Miele H 818 - Enclosed Hotplates; Facia Panel and Controls

Cleaning and care
Enclosed hotplates
Wipe off any spilt food with a damp
cloth after the hotplates have cooled
off. Use a piastre scouring pad if
necessary for stubborn spills. Make
sure that no moisture or soil can pene
trate inside the hotplates. The hot¬
plates can be scoured but not the rim
or hob trough.
To dry the hotplates after cleaning or
whenever they are wet, switch them
ov> for a short while. It is important
for them to be dry to avoid rust
forming.
Occasional treatment with a thin film
of oil or special cleaner for solid hot¬
plates is recommended (for example
Elektro-Puzzi, available to order from
the Miele Spare Parts Dept),
f Hotplate surround
If the hotplate rims or the trough of the
hob are made of stainless steef this
can be cleaned with an appropriate
metal cleaner. Do not use scouring
powder on these parts.
Control knobs and facia, oven front
Do not use any scouring agents or
pads on the knobs ot facia, as this
could cause damage.
Ordinary soapy water or gentle pro¬
prietary cleaners applied to a soft cloth
are recommended for the cleaning
and care of plastic and enamelled
parts, After application rub dry with a
clean cloth.
Ovens with white finish
Each time after cookrng in the oven,
use a damp cloth and some washing
up liquid Of necessary) to clean
- the handle on the oven door
- the trim beside and below the oven
door and round the vents
- the facia panel.
This will avoid fat and spillages being
burnt on and looking unsighlly.
34