Programme options
61
Adjust Sensor wash
You can adjust the Sensor wash
programme so that it will remove
stubborn soiling in a lightly soiled load.
Switch the dishwasher off with the
button, if it is switched on.
Press the /button in and, whilst
holding it in, switch the dishwasher
on using the button.
Keep the /button pressed in for
at least four seconds until the /
indicator light comes on.
If this does not happen, start the
procedure from the beginning again.
Press the button five times.
The indicator light will flash rapidly
five times at intervals.
The flashing sequence in the display
indicates whether "Adjust sensor wash"
is activated or not.
– : "Adjust sensor wash" is switched
on.
– : "Adjust sensor wash" is switched
off.
Press the / button to change the
setting.
The setting is now stored in memory.
Switch the dishwasher off with the
button.
To Next Page
Loading...
Need help?
General
