Problem solving guide
73
With the help of the following guide, minor faults in the performance of the
appliance, some of which may result from incorrect operation, can be put right
without contacting Miele. This will save time and money.
Please note that a call-out charge will be applied to unnecessary service visits
where the problem could have been rectified as described in these operating
instructions.
Unauthorised or incorrect repairs could cause personal injury or damage to
the appliance.
Repair work to electrical appliances must only be carried out by a suitably
qualified and competent person in strict accordance with current local and
national safety regulations. The manufacturer cannot be held liable for
unauthorised work.
Technical problems
Problem Possible cause and remedy
The / indicator light
does not flash after the
dishwasher has been
switched on using the
button.
The appliance is not plugged in.
Insert the plug and switch on at the socket.
The mains fuse has tripped.
Reset or replace the circuit breaker (see data plate
for minimum fuse rating).
The dishwasher stops
during a programme.
The mains fuse has tripped.
Reset or replace the circuit breaker (see data plate
for minimum fuse rating).
If the mains fuse trips again, call Miele.
To Next Page
Loading...
Need help?
General
