Programme options
63
Factory default settings
If you have altered any settings from the
factory default, you can reset them
back to the factory default settings as
follows:
Switch the dishwasher off with the
button, if it is switched on.
Press the /button in and, whilst
holding it in, switch the dishwasher
on using the button.
Keep the /button pressed in for
at least four seconds until the /
indicator light comes on.
If this does not happen, start the
procedure from the beginning again.
Press the button 12 times.
The indicator light will do 1 long
flash and 2 short flashes at intervals.
The flashing sequence in the display
indicates whether a setting has been
changed from its factory default.
– : All settings are set to factory
default settings.
– : At least one setting has been
changed.
To reset the dishwasher to the factory
default settings, press the /
button.
The setting is now stored in memory.
Switch the dishwasher off with the
button.
To Next Page
Loading...
