Miele HS19 - Connecting Key Components

Installation and connection
19
Connecting the Comfort
handle
Depending on how you decide to con-
figure your vacuum cleaner, you can
connect the Comforthandle to either
the suction tube or the PowerUnit.
 Push the Comforthandle down onto
the suction tube connector from
above until it audibly clicks into place
(left image detail).
 Slide the Comforthandle along the
guide line on the dust container
handle and down onto the PowerUnit
connector from above until it audibly
clicks into place (right image detail).
 Switch off the vacuum cleaner using
the On/Off switch on the front of the
Comforthandle if you want to separ-
ate the sections.
 Press the release catch and remove
the Comforthandle by pulling it up-
wards.
Connecting the PowerUnit and
the suction tube
Depending on how you decide to con-
figure your vacuum cleaner, the suction
tube is located either above or below
the PowerUnit.
 Slide the suction tube along the guide
line on the dust container handle and
down onto the PowerUnit connector
from above until it audibly clicks into
place (left image detail).