Maintenance
38
To do this, line up the guides (arrows)
and turn the pre-filter back to its ori-
ginal position.
Close the dust container flap, making
sure it clicks into place.
Reattach the dust container to the
PowerUnit connector.
Cleaning the dust container
Clean the dust container as required.
Remove the dust container.
Empty the dust container over a bin
and lift the pre-filter upwards to re-
move it.
Clean the dust container using water
and mild washing-up liquid.
Dry the dust container thoroughly.
Reinsert the pre-filter in the dust con-
tainer and turn the pre-filter back to
its original position.
Reattach the dust container to the
PowerUnit connector.
Cleaning the Electrobrush/
handheld brush (depending on
model)
Disconnect the Electrobrush/hand-
held brush from the vacuum cleaner.
Place the Electrobrush/handheld
brush upside down on a level, clean
surface.
Cut any threads or hairs that have
wound themselves around the roller
brush with a pair of scissors. To guide
the scissors, move along the guide
track on the roller brush.
To Next Page
Loading...
