^
If the front slat on the facing does not
align with the front edge of the plinth
facing, cut off another slat a.
^ Use pliers to remove the vertical ribs
b.
^
Shorten the ventilation grill supports
b by dimension A
(= ventilation grille bracket
overhang).
^
Secure the plinth facing to the run of
kitchen units a.
^
Push the ventilation grille onto the
bracket c.
Fitting a furniture door
If there are no pre-drilled holes in the
furniture door, holes have to be drilled
as shown on the following drawing:
Drilling positions on framed doors
Installing the appliance
30
To Next Page
Loading...
