Fitting the appliance door
^
Place the door onto hinge pin c.
^
Close the appliance door.
^ Fit hinge plate c onto the opposite
side and secure it with screws d.
^ Fit covers a and b to their opposite
sides.
^ Realign the door with the appliance
housing using the outer long slots in
the lower hinge plate. Then tighten
the screws.
Replacing the SoftClose door
mechanism
^
Remove cover a from panel b,
rotate it by 180° and refit it on the
other side.
^
Insert the SoftClose mechanism back
into the door, starting at the
right-hand side.
^
Using a flat-bladed screwdriver, slide
the SoftClose mechanism towards
the appliance side of the door.
Changing the door hinging
58
To Next Page
Loading...
