The correct temperature
77
Setting the temperature
Touch the symbol for setting the
temperature.
The previously set temperatures of the
Fridge and Freezer Zones are displayed.
Use the and arrow buttons to
select the temperature zone for which
you want to adjust the temperature
and touchOK to confirm your selec-
tion.
Set the temperature you want with
the and sensor controls. Keep-
ing your finger on the sensor control
changes the temperature continu-
ously.
Confirm the temperature setting
withOK or wait approx. 8seconds af-
ter the last touch of the sensor. This
temperature will be automatically
adopted.
Tip: The newly set temperature can also
be confirmed and adopted by closing
the appliance door.
The temperature display always shows
the required temperature.
If you have adjusted the temperature,
wait for approximately 6hours if the
appliance is not very full and for ap-
proximately 24hours if the appliance
is full before checking the temperature
display. It will take this long for an accu-
rate reading to be given.
If, after this time, the temperature is
still too high or too low, adjust it
again.
Temperature range
The temperature can be adjusted:
– From 36°F (2°C) to 46°F (8°C) in the
Fridge Zone
– From 7°F (-14°C) to -11°F (-24°C) in
the Freezer Zone
The temperature in the dry compart-
ment of the MasterFresh zone is regu-
lated automatically and is maintained
just above 0°C (32°F) at a Fridge Zone
temperature of 4°C (37°F).
Please note that if the temperature in
the Fridge Zone is any warmer, the
temperature in the dry compartment of
the MasterFresh zone will rise as well.
The ambient temperature in the room
and the installation location can af-
fect the time it takes for the appli-
ance to reach the lowest tempera-
ture.
If the ambient temperature is too
high, the appliance may not reach
the lowest temperature.
To Next Page
Loading...
Need help?
General
