Protective shelf
After installing the hob, you need to
make sure that the underside of the
appliance cannot be accessed or
touched.
A fascia panel and a protective shelf
must be fitted if:
– no oven or cooker is installed
underneath the hob.
– the appliance is wider than the oven,
cooker or control unit.
–
the appliance and the built-under
oven, cooker or control unit are offset
from one another.
A minimum distance of 55 mm is
required between the upper surface of
the worktop and the protective shelf.
A gap of 10 mm must be maintained
between the shelf and the rear wall.
Sealant
Do not use any sealant unless
expressly instructed to do so. The
sealing strip under the edge of the top
part of the hob provides a sufficient
seal for the worktop.
Do not use sealant between the
frame of the top part of the hob and
the worktop.
This could cause difficulties if the
hob ever needs to be taken out for
servicing and possibly result in
damage to the hob frame or the
worktop.
Installation
48
To Next Page
Loading...
Need help?
General
