Programming
45
You can programme certain settings on
the hob to suit your personal needs.
Several settings can be changed in
succession.
After accessing programming mode,
the symbol and will appear in the
timer display. After a few seconds, :
(Programme 01) will flash alternately
with : (Code) in the timer display.
To access programming mode
With the hob switched off, touch
the and sensors at the same
time until the symbol and
appear in the timer display.
To set the programme
Touch the sensor repeatedly until
the programme number you want
appears in the appropriate number on
the numerical keybank.
For a two digit programme number
you need to first set the tens position
using the numerical keybank.
To set the code
Touch the sensor repeatedly until
the Code you want appears in the
display or touch the appropriate
number on the numerical keybank.
To save the settings
While the programme is showing in
the display (e.g. :) touch the
sensor until the indicators go out.
To avoid saving the settings
Touch the sensor until the
indicators go out.
To Next Page
Loading...
