Switching on, adjusting the
flame and switching off
The control is used to switch on the
burner and regulate the strength of the
flame.
ß the gas supply is turned off
& strong flame
/ weak flame
The burners can only be switched
on by pressing in the appropriate
control and turning it anti-clockwise,
and switched off by turning the
control clockwise.
- Trying to switch on a burner
without pressing in the control,
- Switching on a burner by
turning it clockwise, or
- Switching off a burner by
turning it anti-clockwise,
can damage components in the
appliance. The manufacturer cannot
be held liable for this type of
damage.
To switch on:
^ The control for the burner required
must be pressed in and turned
anti-clockwise to the large flame
symbol to switch on.
^
When the flame ignites, keep the
control pressed in for 8-10 seconds,
and then let it go.
If the flame goes out, repeat the
procedure, keeping the control pressed
in for a few extra seconds.
Using the gas hob
15
To Next Page
Loading...
Need help?
General
